Skip to main content

Device Info

The Device Info panel displays detected device information and provides debugging controls for the current terminal.

Debug Mode​

  • Debug on this Device — Toggle to enable debug mode. When enabled, additional diagnostic information is stored in localStorage and displayed during operation.
  • Test Sentry — Throws a deliberate error to verify that error reporting (Sentry) is working correctly on this device.

Device Type Detection​

Read-only checkboxes showing the detected device type:

  • Mobile Device — Detected as a phone.
  • Tablet — Detected as a tablet.
  • Desktop Device — Detected as a desktop or laptop computer.

SSL Certificate Check (Android Only)​

  • Skip SSL Certificate Check — Toggle to bypass SSL certificate validation on Android devices. Intended for environments using self-signed certificates or internal certificate authorities. Disabled by default. Only visible on Android terminals.

Device Name​

  • Device Name — Enter a name for this terminal. The name is used to identify the device in the POS Device list and for peripheral assignments.
  • Save Name — Persists the device name to localStorage.

Assign the same device name here as the terminal name in the Settings > POS Devices list. This ensures that peripheral settings (printers, card readers) apply to the correct physical device.

Scanner Speed Test​

The panel at the bottom of the Device Info page compares a barcode scanner's two output modes. Scan the same driver license with the scanner in keyboard mode and in COM-port mode, and the panel shows for each scan:

  • Character count and the time from the first to the last character
  • Characters per second
  • Whether the scan was read as a driver license, with the same age checks the POS shows

The panel also has controls to connect/disconnect a COM-port scanner and to adjust the connection speed (baud rate) and the pause that marks the end of a scan. Results are kept on screen only — nothing is stored and the scanned text is not shown. See Barcode Scanners for the COM-port scanner setup.